Kinco FD5P Series - Panel Menu Structure and Navigation

Kinco FD5P AC series servo driver
Chapter 4 Controller setup with LED panel
33
P..L
Positive limit signal active
n..L
Negative limit signal active
Pn.L
Positive and negative limit signal active
FFF.F
The drive is not configured with the motor model
Blinking
Error
4.2
Panel menu structure and navigation
Set drive parameters and monitor real-time data as follows:
Figure
4-1
Parameters Setting
Attention
Press SET setting determining，If the panel shows means failure setting. The
reasons could be:
1.
The setting value is out of the setting range of the parameter.
2.
The drive is in the enabled state, the parameters cannot be changed. You need to
cancel the enable state first.