Kinco FD5P Series - Brake Connection

Kinco FD5P AC series servo driver
Chapter 3 Installation and wiring
28
3.4.4 Brake connection
Table
3-12
Brake connection example
Instruction
By default, OUT2 of the drive is the brake control port. An external relay is required to control the
motor brake. The brake coil of the motor has no polarity.
The 24V output power of the drive X1 is not enough to control the brake, and an external
24V is required as the brake power supply
Brake connection example
Ordinary pulse input wiring
example②
PNP Wiring method
High-speed pulse input wiring
example①
NPN wiring method
High-speed pulse input wiring
example ②
PNP wiring method
Servo driver
Servo driver
Servo driver