Kohler KDI 1903 TCR

EN
252
2.
Insert the shoulder ring E on the flange F and clamp
the gear H using the retainer ring D .
3.
Position flange F on the crankcase K inserting the
gasket J , and inser gear H in crankcase K .
Fig 11.18
1.
Secure the flange F using the screws N (tightening
torque at 25 Nm ).
Fig 1
Important

Always replace rings P and Q after each assembly.
5. Insert the centring ring C in the flange F up to the stop.
6. Position the pump B on the flange F engaging the gear H
.
7. Secure the pump B using the screws A on the flange F
(tightening torque at 25 Nm ).
Fig 11.20