ATTACHMENTS AND OPTIONS HANDLING SERVICE CENTER
6-27
1. Stop the machine on level ground, then stop the engine.
2. Open cover (1) at the front of the power container on the
right side of the machine.
3. Check that the surface temperature of the cap of reservoir
tank (2) is cool enough to be touched by hand, then raise
cap lever (4) of cap (3) at the top of the reservoir tank, and
release the pressure inside the reservoir tank.
4. Remove water filler cap (5).
5. Set drain valve (P) under the machine to open position (O).
6. Remove the cap of coolant coupler (6) and connect the
force-feed pump coupler securely.
7. Start to drain coolant.
8. Start to add coolant.
9. After completing the draining and adding of coolant,
remove the force-feed pump coupler.
10. Install the cap to the coupler.
To Next Page
Loading...
