5
Specifying printer driver settings
5-38 IC-206
4 Specify the desired settings.
– Watermark Text: Type in the watermark text.
– Font: Select the font for the watermark. Any font installed on the
computer can be selected.
– Bold: Select to use bold text.
– Italic: Select to use italic text.
– Size: Specify a character size between 7 and 300 points.
– Angle: Specify the angle that the text is printed on the paper. A
setting between 0° and 359° can be specified.
– Darkness: Specify the density of the text. A setting between 10%
and 100% can be specified.
– Offset from Center: Specify the horizontal and vertical positions for
the location where the text is to be printed. Settings between -100
and 100 can be specified.
– A maximum of 20 characters can be entered for the text.
To Next Page