X75HD/X75SD Installation and Operation Manual 101
Chapter 5: Initial Configuration
Processing Modes
General Information
Video M-Path configuration is performed on the following groups of
video outputs:
• Analog (includes five analog output types: composite, CAV
(Y, B-Y, R-Y), S-video, RGB, Aux-composite)
• HD (with various options, such as HD 1, HD 2, HD-Fiber, and
DVI/HD)
•SD-SDI 1
•SD-SDI 2
• StrV (streaming video
These output groupings are used for configuration purposes. You can
individually set each of these output groups to accept a specific input
source. In addition, there are four special routable blocks in the SDTV
video configuration path that may be included in the input path for any
input signal.
Alternatively, you can use the AllOutSelect parameter to select an input
source for all output groups simultaneously. Table 5-1 summarizes the
video output groups and available input sources.
Note
If you are missing certain option
modules, the corresponding
outputs will not be available.
Table 5-1. Video Output Groups and Available Video Input
Sources
Output
Groups
Physical Outputs
Forming Part of this
Output Group
Input Source to
Assign to Each
Output Group
• Analog
•HD
•SD 1
•SD 2
•StrV
• Composite, CAV, S-Video,
Aux, RGB
• HD 1, HD 2, HD Fiber,
DVI
•SDI 1
•SDI 2
• Streaming
and future-use DV
• Composite
•S-Video
•CAV
•SD 1
•SD 2
• DV (future use)
•HD Fiber
•HD 1
•HD 2
To Next Page
