X75HD/X75SD Installation and Operation Manual 311
Appendix D: Software
Configuring SNMP Support
With SNMP support, you can use a standard MIB browser to monitor
parameters and alarms.
You must set SNMP options using Pilot, CoPilot or Navigator. Before
you can configure SNMP support, you must discover the X75HD/
X75SD. For instructions on discovering this module, see the CCS Pilot/
Navigator online help.
Activating Your SNMP License Key
A license key may have been included in your purchase of an
SNMP-enabled system. Contact Leitch customer service to purchase
one at a later date.
1. While your CCS Software is in Build mode, right click on the
discovered X75HD/X75SD and choose Configuration.
The Configuration window opens.
2. Click on the Device tab.
3. Enter your device key in the License Key field, and then click
Write and Reboot.
4. Close the Configuration window.
Setting SNMP Options
Devices that support SNMP will have an SNMP tab in the
Configuration window. To configure an X75HD/X75SD that supports
SNMP, follow these instructions.
1. While your CCS Software is in Build mode, right click on the
X75HD/X75SD and choose Configuration.
The Configuration window opens.
To Next Page
