256 X75HD/X75SD Installation and Operation Manual
Appendix C: Servicing
Safety Precautions
Only qualified personnel should perform service procedures. Refer to
the X75HD/X75SD Product Safety Instructions booklet before servicing
the X75HD/X75SD or its components.
Laser Caution
This product may contain lasers! Heed the following caution:
ESD Caution
When servicing the X75HD/X75SD and its components, take the
proper precautions to avoid electrostatic discharge (ESD).
Laser Radiation When Open
CAUTION: To avoid damage from laser radiation, do not
remove or displace any connections or protective panels.
CLASS 1
LASER PRODUCT
CLASS 1 LASER PRODUCT
[Finland] LUOKAN 1 LASERLAITE.
[Sweden] KLASS 1 LASER APPARAT.
Preventing Electrostatic Discharge
CAUTION: Electrostatic discharge (ESD) can damage components in the product. To prevent
ESD, observe these precautions when directed:
• Use a ground strap. Wear a grounded wrist strap to discharge the static voltage from your body
while installing or removing sensitive components.
• Use a safe work area. Do not use any devices capable of generating or holding a static charge
in the work area where you install or remove sensitive components. Avoid handling sensitive
components in areas that have a floor or benchtop surface capable of generating a static charge.
• Handle components carefully. Do not slide sensitive components over any surface. Do not
touch exposed connector pins. Handle sensitive components as little as possible.
• Transport and store carefully. Transport and store sensitive components in a static-protected
bag or container.
To Next Page
Loading...
