188 X75HD/X75SD Installation and Operation Manual
Chapter 10: Special Function Buttons
Using the Timing Control
Using the Timing button, you can quickly access the currently selected
video processing block's phase controls. When multiple input video
sources are selected and processed, pressing the Ctrl and V Proc
buttons allows you to switch between the processing blocks and leads
you directly to the selected timing controls.
The Proc LEDs on the right side of the front panel and the display show
the currently selected and active block.
• When the Analog processing block is selected, press the Timing
button to access the AVFS & Timing submenu.
• When an SD processing block is selected, press the Timing button
to access the SD1 FS & Timing or SD2 FS & Timing submenus.
• When the HD processing block is selected, press the Timing button
to access the HD Out V-Phase parameter under the Processing
menu, and press the Exit button to access the HD Out H-Phase
control.
The timing controls for the down-converted signal can be adjusted with
the SD-ARC/HD Dn V-Ph and SD-ARC/HD Dn H-Ph controls from
the Video Setup>Processing menu.
Using Option Controls
The Option control panel shortcut allows quick access to certain
parameters, some of which become enabled with the purchase and
installation of various optional modules and upgrades.
To access the list of Option parameters, press the Option button, and
then select one of the following items:
• History: The last ten parameters that you have viewed or modified
appear chronologically in the History list. The most recent event
appears at the bottom of the list. This list is deleted if the control
panel loses its power.
• Active Alarms: Using this parameter, you can set the parameters
for alarms on your network of X75-RCP-enabled devices. For each
alarm, you can make the following settings:
•Trigger Time
•Clear Time
To Next Page
