X75HD/X75SD Installation and Operation Manual 189
Chapter 10: Special Function Buttons
• Priority
• Alarm Mute
• Acknowledged
• Alarms Log: The last 20 alarms (minor and major) are listed in the
Alarms Log. This is a read-only list; it can only be cleared by
disconnecting power to the control panel.
• Configure Alarms: Use this parameter to set the parameters for
alarms on your network of X75-RC- enabled devices. For each
alarm, you can access the following options:
•Trigger Time
•Clear Time
• Priority
• Alarm Mute
• Acknowledged
For a complete list of all the possible alarms, see page 323.
• Favorite 1 and Favorite 2: Use these two lists to retain the ten
most-needed parameters. With each parameter listing that you wish
to save, press Favorite 1 or Favorite 2 from the Options List, and
then select Add. The message “Item added” appears. See “Using
the FAV1 and FAV2 Function” on page 176 for more information.
• Preset: This shortcut leads you directly to the Memory menu (see
“Using the Memory Function” on page 172).
• MuteKeepAlive: The X75HD/X75SD unit sends out a “keep
alive” message at approximately every 15 seconds. The keep alive
checks to determine if the device is still active and resides on the
control network. The following options are available:
• No: The keep alive message is broadcast every 15 seconds by
the X75 unit to be discovered by the client control systems.
• Yes: Suppresses the keep alive message unless it is requested
by any client control system.
If the X75 is repowered with the Mute KeepAlive option set to
Yes, a client device such as a remote control panel will not be
able to discover the unit until the control panel is repowered.
• Home: This option returns you to the Main menu.
To Next Page
