120 X75HD/X75SD Installation and Operation Manual
Chapter 6: Operation via Front Panel Controls
Changing Parameters
Once you have selected an option from a particular menu or submenu,
use the control knob on the front panel to set the new value for the
parameter by following the methods described below.
Alternatively, you can use the X75-RCP to remotely control the
X75HD/X75SD. See “Configuring Network Settings” on page 88 and
“Remotely Controlling X75HD/X75SD Systems” on page 95 for more
information on configuring the X75HD/X75SD for remote control.
Setting Discrete Options
The control knob cycles through discrete parameter and value options
(such as Auto, On, Off). Depending on the parameter type, it will either
wrap or clip when the control knob reaches the end of the option list.
• A wrapping parameter returns to the beginning of its range/list of
options after you have scrolled through all of them.
• A clipping parameter requires you to scroll back through the
range/list of options to return to the beginning of the list.
Procedure
To set a discrete parameter option, follow these general steps:
1. Navigate to the required menu or submenu, and select a parameter.
2. Highlight a parameter with the control knob, and then press Enter.
3. Press Exit to accept your new value and return to the previous
menu or submenu.
Selected settings affect the output immediately.
To Next Page
