X75SD/X75HD Installation and Operation Manual 23
Chapter 1: Introduction
Typical Control Configurations
The X75HD/X75SD models can be configured, controlled, and
monitored using the following methods:
• Local control panel on X75HD/X75SD models (see the Control
Panels for X75 Systems Installation and Operation Manual for
details)
• X75-RCP remote control panel (see the Control Panels for X75
Systems Installation and Operation Manual for details)
• Local control panel on DPS-575 frames on the same network
• RC-575 Remote control panel
• Web server control, viewable on a browser program such as Internet
Explorer™ (IE) or Netscape™ (see “Configuring for HTTP Control
via Web Browser” on page 98 or “Overview” on page 129 for
details)
• CCS™ (Command and Control System) applications such as Pilot
or Navigator (see the CCS application online help for details)
• SNMP (Simple Network Management Protocol) and third-party
control software through Leitch CCS Protocol (see“Configuring
Third-Party SNMP Software Control” on page 315 for details)
All remote methods of operation involve Ethernet connections. See
Figure 1-4 on page 24 for an illustration of these various control
configurations.
Note
The maximum recommended
length for a standard
10/100Base-T cable is 328 ft
(100 m).
To Next Page
Loading...
