60 X75HD/X75SD Installation and Operation Manual
Chapter 3: Module and Back Panel Descriptions
X75OPT-PQM Module and Back Panel
General Description
The optional X75OPT-PQM module and associated back panel provide
selectable analog composite, component Betacam (CAV), and S-video
inputs (see Figure 3-6). This module is an economical alternative to the
X75OPT-A3D option.
Composite input is processed through a 3D-adaptive comb filter. The
TBC mode is always used when the S-video input is selected. When the
component analog video input is selected, it is converted to digital and
then further processed as required.
Looking from the rear, this back panel is located in the top, right corner
of the frame, above the dual Ethernet ports.
Figure 3-6. PQM-X75 Back Panel
To access, configure, and enable the analog video parameters associated
with this module, enter the Video Setup parameter.
Analog composite
video input connector
S-video input
connector
Component Betacam
video input connectors
Y In
B-Y In
R-Y In
To Next Page
Loading...
