286 X75HD/X75SD Installation and Operation Manual
Appendix C: Servicing
Table C-4. Audio Limiter Options
Option Description
Soft Limit Level
• Sets the threshold level for the input audio signal, measured in dB (decibels),
where the audio signal limiter's attack and decaying function will be based
• When a signal exceeds this level, compression will be applied
Slope
• The amount a signal is reduced by the compressor
• When the slope is set to 0.25, the audio input signal exceeding the soft limit
threshold level will be reduced by a factor of 4 at the output
Attack Time
• Limiter will be activated only after the input audio level remains over the Soft
Limit Level for the duration specified in the Attack Time option
• Audio that exceeds the specified Soft Limit Level for less than the specified
Attack time will not activate the limiter
• Attack Time indicates how long it takes for the compressor to act after a signal
has exceeded the threshold level
Decay Time
• Once the input audio signal has exceeded the Soft Limit Level and the limiter
has been activated, the limiter remains active until the audio signal has returned
below the Soft Limit Level for the duration specified in the Decay Time option
• If the input audio signal returns below the Soft Limit Level for less than the
specified Decay Time, the limiter remains active
Noise Gate Level
• Sets the noise gate threshold level, measured in dB (decibels)
• When an input signal has fallen below this level, the noise gate will be applied
Noise Gate Time Indicates how long it takes for the noise gate to start or stop acting after the input
signal has fallen below or risen above the threshold level
To Next Page
