80 X75HD/X75SD Installation and Operation Manual
Chapter 4: System Installation and Connections
DVI Output
This connector, labelled DVI-Out, is a digital-only transmitter that
provides up to 330 MHz bandwidth signal and supports 1080i/59.94,
1080i/50, and 720p/59.94, and 720p/50 outputs. From this output,
connect the optional X75OPTCAB-DVI DVI-D to DVI-D (digital,
single-link) cable to your DVI monitor.
Composite Video Input
This BNC connector, labelled Cmpst In, is used to feed composite
1 V pk-to-pk 75Ω video to the X75HD/X75SD. The input video signal
must be direct color or monochrome (such as from a satellite feed or
live camera).
S-Video Input
This four-pin mini-DIN connector, labelled S-Video, is used for
S-video (Y/C) signals, such as from an S-VHS or Hi-8 device. The
internal time base corrector automatically processes any signal received
at this port.
Component Analog Video Inputs
These three BNC connectors, labeled Y In, R-Y In, and B-Y In, are
used to input the signals from analog component devices, such as
Betacam VTRs.
If component analog video input is not needed, the CAV-Y In
connection can be reassigned as a second composite video input with
the CAV-Y Composite option in the Video Setup/Analog Input/Proc
menu (see “Chapter 8: Video Configuration” on page 143).
To Next Page
Loading...
