Colortran Encore Control Console
Software Version 3.05
138
1. (REC. DISK)
2. Enter show name, up to 8 characters.
3. [ENTER] (The assigned disk file name
appears in the Setup display
in the File Name field.)
? NOTE: When a file is written to disk, the console automatically
assigns the “.ENC” file name extension, signifying that the file is an Encore
show file. When you are working with files in the console, you do not need to
specify the “.ENC” file name extension.
Reference By Name
You can use the Reference By Name soft key in the Setup display to allow
reference to cues, groups, subs, and effects by their names, as well as by their
numbers. In order to use item names in playback and editing commands, you
must first press the (REF BY NAME) soft key in the Setup display to enable the
Reference By Name feature. Press the (REF BY NAME) soft key again to
disable the feature. By disabling the Reference By Name feature, you can
prevent your Bump buttons from going into Alpha mode when other keys are
pressed ([SUB], [GROUP], etc.).
? EXAMPLE: To enable the Reference By Name feature from the Setup
display:
1. (SYSTM SETUP)
2. (REF BY NAME) (Pressing [ENTER] is not
necessary.)
When you refer to items by name instead of by number, you do not have to use
the entire name. For example, if you have a group named "FRONTBLUE", you
can address it in a command by using the keystrokes [GROUP]
[F][R][O][N][T], or even [GROUP] [F].
To Next Page
Loading...
