Colortran Encore Control Console
Software Version 3.05
158
?
ADVANCED TOPIC: See Moving Cues In Different Track Modes
topic in Chapter 10, Editing Cues and Using Track Modes.
You can use the (RENUM AS) soft key with some retrieve commands to
change the numbers in a list of the items being retrieved. This allows you to
avoid overwriting pre-existing items in memory. The number specified in the
Command Line is assigned to the first item retrieved. All other items retrieved
as a part of the same command are numbered respectively. Any “gaps” in the
item numbering on disk are also reflected in the numbering of the retrieved
items.
? EXAMPLE: Let’s say show 1 is currently in the console and has
cues 1 - 100. Show 2 on disk also has cues 1 - 100. To retrieve specified cues
and renumber them, in the Disk File Management subdisplay:
1. [NEXT] or [LAST] (Highlight show 2 in reverse video
as the default show.)
2. (RETRV CUES) [1] [>] [100] (RENUM AS) [201] [ENTER]
(Cues 1 - 100 are copied from show 2 into show 1, and renumbered as
cues 201 - 300.)
Upgrading Software
The Encore console has the ability to have new versions of software loaded into
it from floppy disk, like upgrading software on a personal computer. The disk
must be an Encore Operating System disk in order for the procedure to function
correctly. Your console was shipped with an Operating System disk that has a
copy of the original software version that was loaded in it when it was tested at
the factory.
?
ADVANCED TOPIC: For complete information about performing
a software upgrade, see Appendix A, Maintenance and Customer Service.
To Next Page
Loading...
