Colortran Encore Control Console
Software Version 3.05
166
pattern and total Cycle Time of each effect. In the Effect display, you can also
test an effect before assigning it to a cue or submaster.
Creating Effects
To create a new "blank” effect, you must be in the Effect display. Use the
(SEL. FX) soft key and assign a number to the new effect. You can also use
this command to view existing effects.
? EXAMPLE: To create a new effect or view an existing effect in the
Effect display:
(SEL FX) [#] [ENTER]
Creating Effect Steps
There are three methods to create the first step in a new effect.
?? (SEL. STEP) soft key
?? Down Arrow [?] key
?? Enter the contents of the first step, which automatically creates step 1.
Effect steps are always created in sequential order. You cannot create the next
step number until you assign channels to the current step. Any step may be left
blank by inserting, copying or renumbering a step. To create subsequent effect
steps in order, you may use the Down Arrow [?], or the (SEL. STEP) soft key.
You can create the contents of an effect step from individual channels or
channel lists. You can assign the contents of a submaster, group, or cue to the
step by using it as a channel list. All channels you enter are assigned to the
current step (the step shown in reverse video).
To Next Page
Loading...
