Chapter 12: Utilities, Warnings, Printing, and Default Settings
Software Version 3.05
143
Dimmer Check Utility
The Dimmer Check utility lets you test the output of individual dimmers. To
start a dimmer check in the Stage display, set an individual dimmer to a level
using the [DIMMER] hard key on the Data Entry Keypad. The Direct Dimmer
Control window appears in the lower left corner of the display. Use the
[NEXT] and [LAST] keys to step through the dimmers sequentially. The
output level of the dimmer you are currently testing is always under control of
the wheel.
To release Direct Dimmer Control from the wheel, press the [CLEAR] key,
select a new command, or press a display key.
? EXAMPLE: To select Direct Dimmer Control in the Stage or
Playback display:
1. [DIMMER] [#] [@] [level] [ENTER]
2. Adjust level with the wheel.
3. [NEXT] or [LAST]
4. [CLEAR] (Dismisses Direct Dimmer Control
window.)
A dimmer check can also be executed using the same method on the Encore's
optional Hand Held Remote.
Channel Check Utility
When you have set a single channel at a level in the Stage display, you can use
the [NEXT] and [LAST] keys to select different channels sequentially. This
allows you to run through a channel check by pressing the [NEXT] key
repeatedly. The channel you are checking is shown in reverse video, and is
always under wheel control.
? EXAMPLE: To run a channel check in the Stage or Playback display:
1. [channel #] [ENTER] (Use the wheel to set the
level.)
- or -
[#] [@] [level] [ENTER]
2. [NEXT] or [LAST], etc.
To Next Page
Loading...
