Leviton MC24/48 - Hand Held Remote Keys and Their Functions

Colortran Encore Control Console
Software Version 3.05
C-4
can cycle through the dimmer list, one dimmer at a time. To release Direct
Dimmer Control, press the [CLEAR] key.
Captured Channels: When you have captured channels under wheel
control, the channels show up on the HHR LCD with their current levels shown
beneath them. These levels can be adjusted with the [UP] and [DOWN] keys,
or by the same kind of commands that you use at the console (e.g., [@] [level]
[ENTER]). If the channel list is too long to be viewed all at once, you can use
the [LAST] and [NEXT] keys (like the Arrow keys on the console) to move the
information that is displayed.
Hand Held Remote Keys and Their
Functions
HHR Key Description Example
. (decimal)
Decimal point
AND (+)
Used to create channel lists. [#] [+] [#]
AT (@)
Assigns a level in a level setting
command.
@ means “at a level of”.
[1] [>] [10] [@] [50]
CLEAR
Backspaces through a partially complete
command or releases captured channels
from wheel control.
CUE
Begins a cue editing command or uses a
cue as a group.
[CUE] [#] [@] [level] [ENTER]
DIM
Begins Dimmer Check command. [DIM] [#] [@] [level] [ENTER]
DOWN (wheel)
Lowers the level of captured channels, or
of a dimmer while in Dimmer Check
mode.
ENTER
Executes a command, or captures all
active channels under wheel control.
FULL
Sets an item to its maximum level. [#] [@] [FULL] [ENTER]
-or-
[#] [FULL] [ENTER]
GO
Starts the next cue in the cue list, or
resumes stopped fades (no [ENTER] is
necessary).
GO TO CUE
Begins a Go To Cue command. [GO TO CUE] [#] [TIME] [#] [ENTER]