Colortran Encore Control Console
Software Version 3.05
162
?
BASIC RULE: Whenever you execute a Record command, the
console assumes that you want to record live levels for all channels, unless you
specify a different list of channels, or specify a list of channels to be excluded
from the list of all channels.
?
ADVANCED TOPICS: See Chapter 24, Selective Recording.
Recalling Groups
To recall a group, use the [GROUP] hard key.
? EXAMPLE: To recall a group in all but the Cuesheet and Setup
displays:
[GROUP] [12] [@] [FULL] [ENTER]
You can assign a level to a group in the Command Line. Levels within the
group read proportionally to the level assignment of the group.
? EXAMPLE: Let’s say group 2 contains channels 1 - 4 at 80%.
To assign group 2 to a proportional level of 50% in the Stage display:
[GROUP] [2] [@] [50] [ENTER]
(Channels 1 - 4 set at 40% on stage
(40%=50% of 80%).)
You can only edit groups in the Group display. An edit to an existing group
affects levels only in the Group display. Edits made to a group are not updated
to any other instances where the group was previously used to set channel
levels.
Copying Groups
You can use the (COPY GROUP) soft key to copy the contents of one group
into another group number in the Group display.
To Next Page
Loading...
