Colortran Encore Control Console
Software Version 3.05
170
?
HINT: If you want all channels to go to zero for a moment before the
Build cycle begins again, insert a step 1 with no channels assigned to it.
?? BOUNCE = Each full cycle of the steps switches between the
Forward and
Reverse patterns.
?? RANDOM = The steps ignore their numerical sequence and
execute in a random
order until all steps have become active once. Then the sequence begins again.
? EXAMPLE: To assign effect patterns in the Effect display:
1. (SEL FX) [#] [ENTER] (Selects effect #.)
2. (PATRN) (Reveals another level of
soft keys.)
3. Press appropriate pattern soft keys to obtain the effects pattern desired.
The selected patterns are
shown in reverse video in the Status Bar.
?
HINT: Experiment to become familiar with the patterns:
1. In the Effect display, create a 5-step effect with channel 1 in step 1,
channel 2 in step 2 etc.
2. Assign a pattern or combination of patterns to the effect.
3. Test the effect (see next topic). Select the Stage display to
view the effect.
4. Repeat these steps with each pattern and different pattern
combinations to see the variety of effect
patterns available.
Testing an Effect
The (TEST FX) soft key gives you an opportunity to view the effect live before
you assign it to a cue or a submaster. Edits can be made "live" to the effect
being tested. The (TEST FX) soft key always loads the selected effect onto
playback fader 4.
? EXAMPLE: To test an effect in the Effect display:
(TEST FX) [#] [ENTER] (The effect loads to
playback fader 4.)
To Next Page
