Colortran Encore Control Console
Software Version 3.05
176
Copying Effects
You can copy effects under the (FX UTIL.) soft key. The source effect in a
Copy Effect command is left intact. If the destination effect already exists, an
Overwrite Warning message appears and requests confirmation before
replacing an effect. The default source effect is the current effect that you are
viewing.
? EXAMPLE: To copy the current effect in the Effect display:
1. (FX UTIL.)
2. (COPY FX) [destination #] [ENTER] (The current
effect # and "@" appear
in Command Line.)
? EXAMPLE: To copy an effect other than the current effect:
1. (FX UTIL.)
2. (COPY FX)
3. [CLEAR] [CLEAR], etc. (Clears current
effect from Command Line.)
4. [source #] [@] [destination #] [ENTER]
Renumbering Effects
You can renumber an effect in the Effect display under the (FX UTIL.) soft key.
This moves the source effect to the new designated destination number and the
source effect number is lost. If the destination effect already exists, an
Overwrite Warning message requests confirmation before replacing it.
? EXAMPLE: To renumber the current effect in the Effect display:
1. (FX UTIL.)
2. (RENUM FX) [destination #] [ENTER] (The current
effect # and "@" appear in
Command Line.)
? EXAMPLE: To renumber an effect other than the current effect:
1. (FX UTIL.)
2. (RENUM FX)
3. [CLEAR] [CLEAR], etc. (Clears current
effect from Command Line.)
4. [source #] [@] [destination #] [ENTER]
Deleting Effects
To Next Page
Loading...
