Chapter 23: Load Key Operations
Software Version 3.05
233
Loading Cues to Submasters
When the Load command loads a cue to submaster, the sub type of the
destination submaster automatically changes to Normal. Regardless of its
current mode, any channel levels that were previously assigned to the Normal
sub are replaced with all the channel levels of the cue. Only channel levels of a
cue are loaded to a submaster - effects assigned to a cue are not loaded to the
submaster. The timing associated with the cue is automatically assigned to the
submaster Bump button as well.
If you load a multipart cue onto a submaster, the "end look", including all parts
of the cue, load onto the submaster. The "look" of that submaster will be as if
all cue parts are completed.
? EXAMPLE: To load a cue to a submaster:
[LOAD] [CUE] [#] [ENTER] [press Bump button]
- or -
[LOAD] [CUE] [#] (ON SUB) [#] [ENTER]
When loading a range of cues to submasters, the cues are loaded to consecutive
submaster numbers, starting with the first submaster indicated. Even if the
range of cue numbers is not consecutive, the cues are loaded to consecutive
submasters.
? EXAMPLE: To load a range of cues to submasters:
[LOAD] [CUE] [#] [>] [#] [ENTER] (Press Bump button of
starting destination sub.)
- or -
[LOAD] [CUE] [#] [>] [#] (ON SUB) [first sub #] [ENTER]
Loading Groups to Submasters
When the Load command loads groups to submasters, the sub type of the
affected submasters automatically changes to Normal. Any channel levels that
were previously assigned to the Normal sub are replaced with the levels of the
group.
? EXAMPLE: To load a group to a submaster:
[LOAD] [GROUP] [#] [ENTER] [press Bump button of destination
sub]
- or -
[LOAD] [GROUP] [#] (ON SUB) [#] [ENTER]
To Next Page
Loading...
