Colortran Encore Control Console
Software Version 3.05
150
Clearing Memory
You can use the Clear soft keys under the (MEMRY OPTNS) soft key in the
Setup display to clear selected items, or clear all items from the show currently
in memory. These Clear soft keys are listed as follows:
?? (CLEAR ALL) = Clears all items in current show.
?? (CLEAR -PATCH) = Clears all items, but saves patch.
?? (CLEAR ITEMS) = Clears selected items. Reveals another level
of soft keys.
?? (CLEAR CUES) = Clears selected cues from current show.
?? (CLEAR FX) = Clears selected effects from current show.
?? (CLEAR GROUP) = Clears selected groups from current show.
?? (CLEAR MACRO) = Clears selected macros from current show.
?? (CLEAR PATCH) = Clears the entire patch table from current
show.
?? (CLEAR PROFL) = Clears selected profiles from current show.
?? (CLEAR SUBS) = Clears selected submasters from current
show.
An item list must be specified when clearing cues, effects, groups, macros,
profiles, and submasters, or else all of the item type will be overwritten. An
Overwrite Warning appears that lists the total number of items that will be lost.
If no item list is specified, then all of the item type will be cleared from
memory.
? EXAMPLE: To clear a selected list of groups from memory:
1. (CLEAR GROUP) [# list] [ENTER] (Overwrite
Warning message appears.)
2. [ENTER]
? EXAMPLE: To clear all of the groups from memory:
1. (CLEAR GROUP) [ENTER] (Overwrite
Warning message appears.)
2. [ENTER]
Track Modes: In all Track modes, the cue following the cleared cues will
be assigned hard levels as necessary so that it contains the same channels and
levels as it did before the preceding cues were cleared.
? EXAMPLE: If in cue 1 channel 4 has a hard level at 50% that
tracks into cue 2, and cue 1 is deleted, then cue 2 will be modified to contain a
hard level at 50% for channel 4.
Performing a “Hard Clear”
To Next Page
Loading...
