Colortran Encore Control Console
Software Version 3.05
174
? EXAMPLE: To copy a step other than the current step:
1. (SEL. FX) [#] [ENTER]
2. (STEP UTIL.)
3. (COPY STEP)
4. [CLEAR] [CLEAR], etc. (Clears current
step from Command Line.)
5. [source #] [@] [destination #] [ENTER]
Renumbering Steps
You can renumber an effect step in the Effect display under the (STEP UTIL.)
soft key. The source step moves to the location of the destination step and
assumes the number of the destination step. The source step will no longer
exist with its original contents and information. The Renumber command
renumbers all steps following the removed source step. No steps are ever
overwritten by the Renumber Step command.
? EXAMPLE: To renumber the current step in the current effect:
1. (SEL. STEP) [#] [ENTER]
2. (STEP UTIL.)
3. (RENUM STEP) [destination #] [ENTER] (Current
step # and "@" automatically
appear in Command Line.)
? EXAMPLE: To renumber a step other than the current step:
1. (SEL. STEP) [#] [ENTER]
2. (STEP UTIL.)
3. (RENUM STEP)
4. [CLEAR] [CLEAR], etc. (Clears
current step from Command
Line.)
5. [#] [@] [#] [ENTER]
Deleting Steps
You can delete a selected step in the Effect display under the (STEP UTIL.) soft
key. All steps following the deleted step are renumbered.
? EXAMPLE: To delete a step number in the current effect:
1. (STEP UTIL.)
2. (DEL. STEP) [#] [ENTER]
To Next Page
Loading...
