Colortran Encore Control Console
Software Version 3.05
74
? EXAMPLE: If the current default in the Patch: By Channel
display is channel 15, pressing the @ key would cause the following to appear
on the Command Line:
"Channel 15 @" (The console is now waiting for you to provide a
dimmer
number list. You do not need to use the [DIMMER] key - the console is
expecting a dimmer number at this point.)
? EXAMPLE: To patch the default channel to a dimmer list in the
Patch: By Channel display:
[@] [# list] [ENTER]
? EXAMPLE: To unpatch the default channel in the Patch: By Channel
display:
(UNPCH CHANL) [ENTER]
? EXAMPLE: To patch the default dimmer to channel 2 in the Patch:
By Dimmer display:
[@] [2] [ENTER]
? EXAMPLE: To unpatch the default dimmer in the Patch: By Dimmer
display:
(UNPCH DIM.) [ENTER]
Patch 1 To 1
Use the (PATCH 1 TO 1) soft key in both the Patch: By Dimmer and Patch: By
Channel displays to patch each control channel to the dimmer of the same
number (i.e. channel 1 at dimmer 1, channel 2 at dimmer 2, etc.). This is the
default setting for the patch table. The (PATCH 1 TO 1) soft key is available in
the Patch display to return the patch to a one to one channel/dimmer
assignment. Parked dimmers, Non-Dim dimmers, proportional dimmer levels,
and profiles are retained when you execute this command. The console
prompts you to confirm the Patch 1 To 1 command with a second press of the
[ENTER] key before the command is executed.
? EXAMPLE: To establish a 1 to 1 patch in the Patch display:
1. (PATCH 1 TO 1) [ENTER] ("OVERWRITE WARNING”
confirmation request appears.)
2. [ENTER] (Executes the command.)
To Next Page
Loading...
