2-100 Service Manual
5060-4xx
Ready bin x full message - may be able to clear message and will feed paper into bin
selected.
Note: This sensor is normally in a open position with the flag out of the sensor slot.
Bin x full - no message that bin x is full message
Step Action and questions Yes No
1 Bin x sensor (bin x=Sensor 1 through 5) - Make sure
the sensor is seated correctly in the side of tray x.
Is the sensor seated correctly?
Go to step 2 Install the sensor
correctly
2
Bin x sensor cable - Make sure that bin x sensor cable
is connected to the sensor and to the control board.
Is the sensor cable connected correctly?
Go to step 3 Install the sensor
cable correctly
3
Bin x sensor flag - Check the bin x sensor flag for
binding and proper operation.
Are there any problems with the sensor flag?
Repair or replace
the sensor flag
Go to step 4
4
Bin x sensor cable - Check the continuity of the sensor
cable.
Is there continuity?
Replace the bin x
sensor
Replace the bin x
Cable
Step Action and questions Yes No
1 Bin x sensor (bin x=sensor 1 through 5) - Make sure
the sensor is seated correctly in the side of tray x.
Is the sensor seated correctly?
Go to step 2 Install the sensor
correctly
2
Bin x sensor cable - Make sure that bin x sensor cable
is connected to the sensor and to the control board.
Is the sensor cable connected correctly?
Go to step 3 Install the sensor
cable correctly
3
Bin x sensor flag - check the bin x sensor flag for
binding and proper operation.
Are there any problems with the sensor flag?
Repair or replace
the sensor flag
Go to step 4
4
Bin x sensor cable - Check the continuity of the sensor
cable.
Is there continuity?
Replace the bin x
sensor
Replace the bin x
cable
To Next Page
Loading...
