2-32 Service Manual
5060-4xx
34 Incorrect
Media
Change <source>
<type><size>
This message is displayed when the printer detects a media
mismatch.
Primary Message: 34 Incorrect Media.
Secondary Message: <type>= Bond, Cardstock, Colored,
Labels, Envelopes, Letterhead, Plain, Preprint,
Transparency or Glossy. <size>= Letter, Legal, B5, A4,
Exec, Univ, A5, A3, 11x17, Folio or Stmt, 73/4, 9, 10, DL,
C5, B5 or other.
The following actions can be taken:
• Replace the media in the source with the requested
media and press Go
or
• Press Menu to access the Busy/Waiting Menu.
The following functions are available using the Busy/Waiting
Menu:
•Cancel Job
• Reset Printer
• Reset Active Bin
• Check Supply Levels
Note: Menu Lockout does NOT prevent access to the Busy/
Waiting Menu.
Note: If message persists, go to “BASE SENSOR TEST”
on page 3-30 and check operation of inline media sensor.
34 Short Paper This message is displayed when the printer determines that
the paper length is too short to print the data as formatted.
The following actions can be taken:
• Press Go to clear the error and continue printing pages
or
• Press Menu to access the Busy/Waiting Menu.
The following functions are available using the Busy/Waiting
Menu:
•Cancel Job
• Reset Printer
• Reset Active Bin
• Check Supply Levels
Note: Menu Lockout does NOT prevent access to the Busy/
Waiting Menu.
35 Res Save Off
Deficient Memory
This message displays when the printer lacks sufficient
memory to enable Resource Save. This message usually
indicates the user has allocated too much memory for one
or more of the printer link buffers; however, modification of
other printer settings which affect the amount of available
memory may also create this condition. If restoration of
Resource Save is required after this message is received,
the customer should install additional memory or set each
link buffer to Auto. Once all link buffers are returned to Auto,
you should exit the menus to activate the link buffer
changes. Once the printer returns to the Ready state, you
can then enable Resource Save and go back and modify the
link buffers, again. Note the reduction of available memory
to the link buffers when Resource Save has been enabled
and compare it to the memory available when Resource
Save is disabled.
User primary
message
User secondary
message
Explanation
To Next Page
Loading...
