2-36 Service Manual
5060-4xx
53 Unformatted Flash This message is displayed when the printer detects an
unformatted flash at POST.
Press Go to clear the message.
The flash is marked bad and normal operation continues.
Flash operations are not allowed until the flash is formatted.
54 Std Par ENA
Connection Lost
This message is displayed when the printer detects during
POST that the connection to an ENA has been lost. Once a
connection is initially established, a printer setting is
modified to 54 Par x ENA to note a connection exists. Each
time the power is cycled on, the connection is lost.
54 Std Network
Software Error
This message is displayed when the RIP software detects
that a network port is installed but cannot establish
communications with it.
54 Network x
Software Error
Press Go to clear this message.
The printer disables all communications to the associated
network interface. No data may be received or sent from or
to the associated interface. The user can program new
firmware in the network using the parallel port after this
message clears.
54 Serial Option x
Error
This message is displayed when a serial error, either
framing, parity or overrun, is detected on the specified
(option x) serial port. This usually means the serial port is
not set up correctly.
Press Go to clear the message and continue processing the
print job.
Note: If the print job does not print correctly, make sure that
the correct cable is being used.
55 Unsupported
Option in Slot x
55 Unsupported
Flash in Slot x
This message displays when an unsupported option is
installed or when an unsupported flash DIMM, such as a
C750 version, is installed in a memory slot.
Turn off the printer and remove the offending option.
56 Serial Port x
Disabled
These messages may appear when data is sent to the
printer across a serial port, but the port is disabled.
Note: Once the error is displayed the first time, reporting of
further errors is suppressed until the printer is reset or
menus are entered.
The following actions can be taken:
• Press Go to clear the message. Any data received on
the serial port is discarded.
• Press Menu to access the Busy/Waiting Menu.
The following functions may be available:
• Reset Printer
• Reset Active Bin
• Check Supply Levels
Note: Menu Lockout does NOT prevent access to the Busy/
Waiting Menu.
User primary
message
User secondary
message
Explanation
To Next Page
Loading...
