March 13, 2020
• Updated the Supported paper sizes, types, and weights topics in the General information chapter.
• Added the Base printer symptoms topics and service checks in the Diagnostics and troubleshooting chapter.
• Added the Entering recovery mode topic in the Service menus chapter.
• Added links for video demonstration on the following topics in the Parts removal chapter:
– ADF roller removal
– ADF separator roller removal
– Fuser removal
– MPF pick roller and separator pad removal
– Staple
finisher
option removal
– Transfer roller removal
February 5, 2020
• Authentication device, TWN4 USB front reader kit (41X2615) was added to the Miscellaneous Parts catalog.
January 30, 2020
• Updated the Service Engineer menu topics in the Service menus chapter.
• Updated the Fax reception service check topic in the Diagnostics and troubleshooting chapter.
• Updated the Updating the printer firmware topic to include using a USB cable connection option.
• Added the Optional 550‑sheet tray, lockable (41X2813) in the Parts catalog chapter.
• Added the Optional 550-sheet tray insert (lockable optional tray) (41X2814) in the Parts catalog chapter.
• Updated safety information on caution statements.
September 23, 2019
• Translations were added in the Notices, conventions, and safety information section.
July 1, 2019
• Staple finisher mounting bracket (41X1252) was added to the Staple finisher option parts catalog.
June 17, 2019
• Sensor (narrow media) (41X1241) was added to the Electronics 4 Parts catalog.
• Critical information for controller board or control panel replacement was added to the Parts removal section.
February 22, 2019
• Error codes were added to the 6yy errors section.
• An error code was added to the 200 paper jam messages.
January 18, 2019
• Control panel front cover (41X0543) was added to the Control panel Parts catalog.
October 23, 2018
• Bezel (41X2609) FRU was added to the Control panel parts catalog.
• Fax symptoms section was added.
7018
Change history
18
To Next Page
Loading...
