Menu item Description
Scanner Configuration
Edge Erase
ADF Edge Erase
0–6 (3*)
Flatbed Edge Erase
0–6 (3*)
Set the size, in millimeters, of the no‑print area around an ADF
or flatbed scan job.
Scanner Configuration
Disable Scanner
Enabled*
Disabled
ADF Disabled
Disable the scanner if it is not working properly.
Scanner Configuration
Scanner Manual Registration
Print Quick Test
Print a test page that shows the scanner margin settings.
Scanner Configuration
Ti Byte Order
CPU Endianness*
Little Endian
Big Endian
Determine the byte order of a TIFF‑formatted scan output.
Scanner Configuration
Exact
Ti
Rows Per Strip
On*
O
Set the RowsPerStrip tag value of a TIFF‑formatted scan output.
Note: An asterisk (*) next to a value indicates the factory default setting.
Entering Invalid engine mode
This mode allows the printer to load the correct
firmware
code.
1 Turn
o
the printer.
2 From the control panel, press and hold the 3, 4, and 6 while turning on the printer.
3 Release the buttons after 10 seconds.
Entering Recovery mode
This mode allows the printer to boot from a secondary set of instructions and
flash
firmware
code. While in this
mode, you can only
flash
firmware
code through a USB cable directly connected to a PC.
Depending on your printer model, do any of the following:
7018
Service menus
193
To Next Page
Loading...
