For 2.8‑inch display
1 Turn
o
the printer.
2 Open tray 1.
3 Make sure that paper is loaded in tray 1.
4 Turn on the printer.
5 When the display shows the following icon, close tray 1.
Note: If tray 1 is not closed, then the printer will boot normally.
6 A screen with red selection items appears.
Tou ch ‑> to navigate to Recovery mode.
7 To uc h Boot or RECOVERY.
Service Engineer menu
Entering the Service Engineer (SE) menu
To access the Service Engineer (SE) menu:
1 Turn on the printer.
2 When the home screen appears, press * * 411 on the control panel.
For 2‑line control panels, press the right arrow button twice, press OK, and then press the left arrow button.
General SE Menu
• Capture Logs to USB Drive
Note: This setting allows you to save a log
file
to a USB drive.
• Code Versions
• Debug Level
Network SE Menu
Enter the SE menu, and then select Network SE Menu.
7018
Service menus
195
To Next Page
Loading...
