6yy errors
600‑680 error messages
Error code Description Action
600.01 Toner tally from the RIP was not received. See
“Engine error service check” on
page 152.
600.02 Video did not start.
600.04 Duplex page was not picked.
600.05 Invalid PH NVRAM Type error was detected.
600.06 Paperport driver is unresponsive.
600.07 Page is at image point before EP is ready.
600.09 EP update error was detected.
600.10 EP late run‑in error was detected.
600.95 RIP intentionally declared a jam error, usually to
prevent a kiosk user from printing free pages.
602.19 Tray 1 was unable to be ready for picking.
602.29 Tray 2 was unable to be ready for picking.
602.39 Tray 3 was unable to be ready for picking.
602.49 Tray 4 was unable to be ready for picking.
611.02 An Input ISR error occurred and the printhead was
not ready.
See
“Printhead communication error service
check” on page 152.
611.32 Lost Hsync errors were detected. Laser safety
interlock system may be the cause.
611.33 Lost Hsync errors were detected during servo. See
“Printhead error service check” on
page 130.
611.34 A mirror motor lock error was detected. See
“Printhead communication error service
check” on page 152.
655.80 Motor (cartridge) does not turn on. See
“Cartridge drive failure service check” on
page 143.
655.81 Motor (cartridge) does not turn o.
655.82 Motor (cartridge) speed did not ramp up to the
required level.
655.83 Motor (cartridge) has stalled.
655.84 Motor (cartridge) ran too slow.
655.85 Motor (cartridge) ran too fast.
655.86 Motor (cartridge) ran too long.
7018
Diagnostics and troubleshooting
150
To Next Page
Loading...
