Lexmark XM3250 - Change History

Change history
Change history
November 17, 2020
• Updated the graphic in the Electronics 4 topic in the Parts catalog chapter.
October 8, 2020
• Added the MB2650adwe model in the Printer model configurations topic in the General information chapter.
• Updated the descriptions of the following parts in the Electronics 4 topic in the Parts catalog chapter:
– Integrated wireless card (MB2650adwe) (41X2894)
– Wireless cable (MB2650adwe) (41X2270)
September 8, 2020
• Added the ADF separator roller (high torque) (41X2855) in the Imaging topic in the Parts catalog chapter.
• Added a note in the Jam access cover removal topic in the Parts removal chapter.
August 5, 2020
• A note has been added in the Restoring the printer configuration after replacing the controller board topic
in the Parts removal chapter.
• An installation note has been removed from the Controller board removal topic in the Parts removal chapter.
July 14, 2020
• A note for obsoletion was added to the following parts in the Parts catalog chapter:
– Font card, Traditional Chinese (41X1014)
July 9, 2020
• Authentication device, TWN4 USB front reader kit (41X2615) was removed from the Miscellaneous Parts
catalog.
• Updated table in the Print engine layout topic in the Theory of operation chapter.
May 15, 2020
• The following parts were added to the Electronics 4 Parts catalog:
– Wireless cable (41X2270)
– Integrated wireless card (41X2894)
– Front USB host cable (41X2630)
• Updated graphics in the Solid black pages check topic in the Diagnostics and troubleshooting chapter.
• Updated the following connectors in the Wiring diagram:
– USB type A
– Integrated wireless/ Internal solutions port
– Sensor (index)
– Staple finisher connector
7018
Change history
17