FLIR Client 12 for PC / Mac
13
8. (OPTIONAL) Use the Copy function to copy your settings to another or all connected
cameras. See 13.6.1 Copying Channel Settings to Another Channel, page 98 for de-
tails on using the copy function.
13.6.6 Setting the Recording Schedule
The recording schedule determines the time periods that the system will record video dur-
ing. You can set separate schedules for continuous and motion recording for the same
channel.
To set a recording schedule:
1. Click Remote Setting in the top-right corner of the window.
2. Under Settings, click REC Para, then click on the Schedule tab.
3. Use the dropdown next to Channel to select a channel to set the recording schedule
for.
4. Use the dropdown next to Week to select the day of the week you would like to set the
schedule for.
5. The times of day during which continuous recording is enabled are represented by
green bars, and motion by yellow. By default, the system is set the record at all times.
Click-and-drag to enable or disable continuous or motion recording during a certain
time of day.
NOTE
Repeat steps 4 & 5 for as many days of the week as you would like to configure the schedule for.
6. If needed, use the Copy functions to copy the schedule for one day to other days of
the week, or to copy one channel’s entire schedule to other channels.
7. Click Save.
13.6.7 Configuring System Recording Quality (Mainstream and Substream)
The system uses 2 recording streams: the Mainstream is the high-quality stream used for
live viewing and recording, while the Substream is a lower quality stream used for remote
viewing and playback. This allows you to record high-quality video locally, as well as re-
view video remotely with relatively low bandwidth requirements.
To configure the Mainstream:
#LX400086; r. 1.0/39246/39246; en-US
102
To Next Page
Loading...
Need help?
General