FLIR Client 12 for PC / Mac
13
1. Click Remote Setting in the top-right corner of the window.
2. Under Settings, click REC Para, then click on the MainStream tab.
3. Use the dropdown next to Channel to select a channel to configure the mainstream for.
4. Use the dropdown next to Resolution to set the recording resolution.
5. Use the dropdown next to FPS to set the number of frames per second.
6. Use the dropdown next to Bitrate Control to set the control method. Select CBR (de-
fault) to use a Constant Bit Rate, or VBR for a Variable Bit Rate. For VBR, use the sec-
ond dropdown to select a quality level for the video stream.
7. Use the dropdown next to Bitrate Mode to set the bitrate mode. Select Predefined to
select a preset value from the Bitrate dropdown, or User-defined to enter a custom
bitrate.
8. Use the dropdown next to Bitrate to set the bitrate mode (predefined bitrate mode), or
enter a custom bitrate between 1024-8192Kbps (user-defined bitrate mode).
9. Click the switch next to Audio to enable (
) or disable ( ) audio on the selected
channel (audio-enabled camera required).
10. Click Save.
11. (OPTIONAL) Use the Copy function to copy your settings to another or all connected
cameras. See 13.6.1 Copying Channel Settings to Another Channel, page 98 for de-
tails on using the copy function.
To configure the Substream:
1. Click Remote Setting in the top-right corner of the window.
2. Under Settings, click REC Para, then click on the SubStream tab.
3. Use the dropdown next to Channel to select a channel to configure the substream for.
#LX400086; r. 1.0/39246/39246; en-US
103
To Next Page
Loading...
Need help?
General