Installation
Lorrca Maxsis User Manual Page 43
Version 5.04 MRN-231-EN
Tie-wraps.
Safety plate on pinch valves
9. Unscrew the bolt from the pump assembly
10. Check/place the correct fuse (F). According ID-plate. Factory default is 230VAC. See section
Replace the main fuses (on page 170)
11. Fill the bottle de-ionized water. Fill the bottles for the Osmoscan.
12. Place the bottles and connect them according the labels. See drawing LORC070020 Tubing
diagram (on page 219)
13. Place tube cassettes of the gradient pump
14. Connect power cables to grounded sockets.
WARNING: Always connect to grounded wall sockets.
To Next Page
Loading...