LSIS LSLV-S100 - Page 214

200
Learning Advanced Features
Code
Description
Outputs a signal when communication power and
expansion an I/O power card is installed, and also
outputs a signal when losing analog input and
communication power commands.
14
RUN
Outputs a signal when operation command is entered
and the inverter outputs voltage.
No signal output during DC braking.
15
Stop
Outputs a signal at operation command off, and when
there is no inverter output voltage.
16
Steady
Outputs a signal in steady operation.
17
Inverter line
Outputs a signal while the motor is driven by the
inverter line.
18
Comm line
Outputs a signal while the motor is driven by a
commercial power source. For details, refer to 5.19
Supply Power Transition on page 178.
19
Speed search
Outputs a signal during inverter speed search
operation.
For details, refer to 5.15 Speed Search Operation on page
170.
22
Ready
Outputs signal when the inverter is in stand by
operation and ready to receive an external operation
command.
28
Timer Out
A timer function to operate terminal output after a
certain time by using multi-function terminal block
input. For more details, refer to
5.30 Timer Settings on
page 188.
29
Trip
Outputs a signal after a fault trip
Refer to 5.32 Multi-Function Output On/Off Control on
page 190.
31
DB Warn %ED
Refer to 6.2.5 Dynamic Braking (DB) Resistor
Configuration on page 218.
34
On/Off Control
Outputs a signal using an analog input value as a
standard.
Refer to 5.32 Multi-Function Output On/Off Control on
page 190.