Learning to Perform Basic Operations
8
Press the [ENT] key.
The Frq code in the Operation group is set to 0 (Keypad).
9
Press the [▲] key to change it to 2 (Potentiometer), and then
press the [ENT] key.
The new parameter value will flash.
10
Press the [ENT] key once again.
The Frq code is displayed again. The frequency input has
been configured for potentiometer.
11
Press the [▼] key 4 times.
Returns to the first code of the Operation group (0.00). From
here frequency setting values can be monitored.
12
Adjust the potentiometer to increase or decrease the
frequency reference to 10Hz.
-
13
Press the [RUN] key on the keypad.
The RUN indicator light flashes and the FWD indicator light
comes on steady. The current acceleration frequency is
14
When the frequency reaches the reference (10Hz), press the
[STOP/RESET] key on the keypad.
The RUN indicator light flashes again and the current
deceleration frequency is displayed. When the frequency
reaches 0Hz, the RUN and FWD indicator lights turn off, and
the frequency reference (10.00Hz) is displayed again.
[Wiring Diagram] [Operation Pattern]
The instructions in the table are based on the factory default parameter settings. The inverter may not
work correctly if the default parameter settings are changed after the inverter is purchased. In such
cases, initialize all parameters to reset the factory default parameter settings before following the
instructions in the table (refer to 5.23 Parameter Initialization on page 181).
To Next Page
Loading...
