Megger Baker DX - Applicable Standards; Calibration Information

Technical specifications, calibration, and applicable standards
megger.com 135
Calibration Information
New Baker DX testers are calibrated at the manufacturing facility before shipping. Calibration is
recommended annually to ensure continued optimum performance.
For more information, please contact Megger Baker Instruments, Fort Collins, CO for current
calibration information. You may also contact the Service department at (970) 282-1200 or
(800) 752-8272.
Applicable Standards
 EASA Standard AR100-1998 Recommended Practice for the Repair of Rotating Electrical
Apparatus
 IEC 60034-1 (1999-08) Consolidated Edition, Rotating Electrical Machines Part I: Rating
& Performance Ed. 10.2
 IEEE 43-2000 Recommended Practice for Testing Insulation Resistance of Rotating
Machinery
 IEEE 95-1977 Guide for Insulation Maintenance of Large AC Rotating Machinery
 IEEE 112-1991 Test Procedures for Polyphase Induction Motors and Generators
 IEEE 113-1985 Guide on Test Procedures for DC Machines
 IEEE 115-1983 Test Procedures for Synchronous Machines
 IEEE 429-1972 Evaluation of Sealed Insulation Systems for AC Electric Machinery
Employing Form-Wound Stator Coils
 IEEE 432-1992 Guide for Insulation Maintenance for Rotating Electrical Machinery (5 hp
to less than 10,000 hp)
 IEEE 434-1973 Guide for Functional Evaluation of Insulation Systems for Large High-
Voltage Machines
 IEEE 522-1992 Guide for Testing Turn-to-Turn Insulation on Form-Wound Stator Coils
for Alternating-Current Rotating Electric Machines
 IEEE 1415-2006 Guide for Induction Machinery Maintenance Testing and Failure Analysis
 IEC 61934 for PD and IEEE 927 (for PD)
Referenced EMC Standards Referenced Safety Standards
EMC Directive 2004/108/EC EN 61010-1:2001 Second Edition
IEC 61000-6-2, Second Edition: 2005
IEC 61000-6-4, Second Edition: 2006
CISPR 11:2004
EN 61000-3-2:2006
EN 61000-3-3:2005