Megger Baker DX - Cleaning and Decontamination; Power Requirements; Environmental Conditions; General Operation, Maintenance, and Service Information

General Operating Information
6 Baker DX 71-030 User Guide EN V10 www.megger.com
General Operation, Maintenance, and Service Information
Cleaning and Decontamination
Keep the unit clean and in a dry environment. To clean the unit, power down and unplug the
instrument. Wipe with a clean, water dampened cloth. Do not submerge in water or other
cleaners or solvents. To clean the screen, take a soft, water dampened cloth and gently wipe the
surface.
Unpacking the Unit
Carefully remove the following items from the shipping box:
 Baker DX
 Power cord
 Operation manual (digital media only)
Pollution Degree II
(From IEC 61010-1 3.6.6.2) Only non-conductive pollution occurs. However, temporary
conductivity caused by condensation is expected.
Power Requirements
Using the provided AC power cord, connect the unit to a grounded AC power source. The unit’s
power requirements are 100–240 V AC, 50–60 Hz,
2 amps AC maximum current draw. An auto-reset circuit breaker protects the unit.
Environmental Conditions
 The unit has been tested for use up to 2,000 m (6,500 ft.).
 Only operate the tester in temperatures ranging from 5 to 40° C (41 to 104° F).
 This unit is for use at a maximum relative humidity of 80% for temperatures up to
31 °C (88 °F), decreasing linearly to 50% relative humidity at 40° C (104° F). This unit is
intended for Installation Category II in a Pollution Degree II environment.