Chapter 6 Settings
169
Item
Setting
*1
Details
Day Monday to
Sunday
Sets whether to turn on or off the power on each day of the
week.
Nozzle Check ON/OFF Automatically executes the nozzle check function when the
machine is started with auto power-on. Performs nozzle
recovery (cleaning followed by nozzle checking) if "nozzle
clogging" is detected.
Cleaning Soft/Normal/
Hard
Sets the cleaning type.
Retry Count 0 to 3 times Performs nozzle recovery (cleaning followed by nozzle
checking) for the specified number of times.
Top Blower ON/OFF Sets the blowing fan operation during printing.
Strength AUTO/Low/
High
Sets the blowing fan wind strength.
Drying/Exhaust Fan - Set when the optional drying/exhaust fan is used. For more
information, refer to the operation manual for the drying fan unit.
Stop Time OFF/10 to 120
min
Sets the time during which the drying/exhaust fan operates after
printing. After the set time passes, the fan stops.
ON/OFF ON/OFF Set to "ON" to operate the drying/exhaust fan when printing is
not performed.
Use PR Number Query
*CJV only
ON/OFF Sets whether to display the screen for entering the number of
pinch rollers to be used after media width detection.
• ON: Displays the input screen.
• OFF: The "host" takes priority. Set this to "OFF" when
configuring pinch roller pressure settings on this machine.
"Setting the Pressure and Number of Pinch Rollers to
Use"(P. 77)
WhiteSpace Setting - Sets the offset value from the media left and right standard
margins (15 mm).
• The left and right margins should be set to at least -5 mm
when using the media holder. This eliminates the risk of
printing on top of the media holder.
• The Mimaki RIP software (RasterLink) does not allow the
user to specify margins. If the machine is set to "Host", the
offset value will be "0 mm" for the left and right margins.
Margin -
Margin/Left Host/-10 to 85
mm
Margin/Right
Space Btwn PP. None/10 to
500 mm
The space between prints can be eliminated for continuous
printing.
• Reducing the space length may cause media sagging,
resulting in discrepancies in the distance the media is fed.
Space Feed Mode Intermittent/
Continuous
Alters the feed method for blank space included in the image
data.
• Intermittent: Uses intermittent feeding based on the timing of
a fraction of the pass.
• Continuous: Feeds forward by skipping blank parts.
View Feed ON/OFF Sets whether or not to feed the media forward to view the print
results—for example, during test printing.
Feeding Before Cut ON/OFF Sets whether to feed media before cutting the media.
Illumination - Turns the light inside the printer on and off.
LightingUp Type Auto/Manual Sets whether to turn the light on or off during printing and when
the cover is opened.
6
To Next Page
Loading...
Need help?
General
