MIMAKI JV330 Series User Manual

Chapter 8 Troubleshooting
240
Error
number
Message Cause Corrective action
702 Thermistor Connect • A problem was detected
with the thermistor
connection.
• Turn off the power on the machine
and turn it on after a while.
703 Heater Brk • A problem was detected
with the heater
temperature.
710 Heater Temp Error • A problem was detected
with the heater
temperature.
• This error will be automatically
resolved. If the error is not resolved,
Turn off the power on the machine
and turn it on after a while.
801 (C)OPCODE • A problem was detected
with the main PCB.
• Turn off the power on the machine
and turn it on after a while.
802 (C)SWI
803 (C)PFTCHABRT
804 (C)DATAABRT
806 FW/SIO bit • A communication error
was detected between the
boards.
808 FW/STP-MTR** • A problem was detected
with the main PCB.
80f FW/SIO Vch • A communication error
was detected between the
boards.
811 FW/SIO read • A communication error
was detected between the
boards.
81b FW/STACK OV • A problem was detected
with the main PCB.
828 PRG ERR L*****
901 Operation Error • The function is disabled
due to an error.
• Check the error details.
– Media Undetected
– Ink Error
– Waste ink tank, etc.
902 Data Remain • Print (RIP) data was
received.
• Switch to REMOTE mode and start
printing or clear the data and abort
printing.
90f Print Area Short • The media is too small for
the print.
• Replace with wider or longer media.
• If the printable area is reduced due
to a shift in the origin, move the
origin to increase the size of the
printable area.
b02 PCB CTC • The cutter IO PCB could
not be detected.
• Turn off the power on the machine
and turn it on after a while.
b1a PCB BaseIO • A communication error
was detected between the
boards.
b1b BaseIO PCB Vpow-s • A problem was detected
with the Base IO PCB
power supply.
b1c BaseIO PCB V24

MIMAKI JV330 Series Specifications

General

Brand	MIMAKI
Model	JV330 Series
Category	Printer
Language	English