Chapter 2 Printing
70
• To use unregistered media, select [Unregistered] to register the media. "Registering
the Media"(P. 75)
20
Detect the media width.
• No change: Only the right side of the media is detected.
• Media width re-detection: The media width is detected.
PVC
Media Width 1300 mm
No change
Media width
re-detection
• If the media width detection method is set to "MANUAL", set the media width manually
([MENU] > [Media Setting] > [Media Information] > [Media Width] > [Detection Type]
P. 161).
• If Media Remain Manage is set to "ON", the Input Media Length screen will be displayed.
([MENU] > [Media Setting] > [Media Information] > [Media Remain] > [Media Remain
Manage] P. 161).
• A notification reading "Media Set Position R" will appear after media width detection if the
media is too far to the right of the specified position. Reload media in the specified
position.
21
(CJV only) Enter the number of pinch rollers being used.
• If the setting for [Function Setting] > [Use PR Number Query] is "OFF", the screen for entering the
number of pinch rollers will not be displayed.
22
Load an empty paper core on the take-up unit.
23
Press to feed the media until it reaches the paper core on the take-up unit, then press the
[ENTER] key.
• Do not put media through the XY slitter.
24
Secure the middle of the media to the paper core with adhesive tape.
To Next Page
Loading...
Need help?
General
