Special Imaging Modes
11-19
Select [Single], system displays one image, which can be a sectional image or a 3D
image.
Select [Dual], system displays two images left and right. (The left one can be section A,
section B or section C image, and the right one is 3D image.)
Select [Quad], system displays four images. (The upper left one is section A image, the
lower left one is sectional C image, the upper right one is section B image, and the lower
right one is 3D image.)
Sectional plane view
The principle of 3D imaging is to render a 3D image from multiple 2D image information.
Sectional plane position
Enter the quad display format view; there are 3 sectional planes (A, B and C) and the
3D image.
To understand the sectional plane, please refer to “11.1.1.4 Sectional Plane”.
Procedures
1. Set a section (A, B or C) as the current window.
2. Set [Adjusting VOI] as off to enter the sectional plane viewing.
3. Roll the trackball to view the sectional plane.
To Next Page
Loading...
