DICOM
A-19
3. Select DICOM in the “Target” list; select a server in the “Print Server” list.
4. Click [OK] to start the sending.
Send images to DICOM Print server by shortcut key.
1. You can send single frame image or multi-frame images to DICOM Print server by
shortcut key:
z Print Single Frame Image to DICOM Server
2. You can select [Print] key, [Save] key, [F1] - [F10] key on the control panel, or left and
right footswitch keys as user-defined keys.
3. Define the short-cut key: operation is similar to operations in “Send images to DICOM
Storage server by shortcut key”.
4. Set the default server: operation is similar to operations in “Send images to DICOM
Storage server by shortcut key”.
5. Press XX on the control panel (assigned as the shortcut key for “DICOM Print Single
Frame Image to DICOM Server), then the system sends the image to the print server.
Send to DICOM print when ending the exam automatically:
1. Enter [Setup] (by pressing <Setup>)→[System Preset]→[General Preset].
2. Check “Send/Print Image after End Exam”. As shown in figure below.
To Next Page
Loading...
Need help?
General
