Minebea Intec PR 5230 - Page 103

Note:
The IP address and the subnet mask are set at - [Fieldbus parameter] (see also
Chapters 7.15.5 and 12.2).
The EDS le is stored on the CD supplied with the device (eldbus directory of the
respective device). The current le is also available for download via the Internet.
http://www.minebea-intec.com
4.6.10.1 Controls on eldbus card

NOTICE
The  DIL switch settings will not be used.
Make sure that the switches 18 are set to position "OFF."
Settings are dened via - [Fieldbus parameter].
4.6.10.2 status indicator
Requirements:
- The items are dened via - [Display items]- [Fieldbus LEDs]; see Chapter 7.15.7.
- PR 1721/46 is selected via - [HW-Slots]- [Slot 2].
Display:
LEDs in device:

1 2 3 4
Constant ---:
No connection
Constant ---:
No power
Constant ---:
No function
Constant ---:
No power or no IP
address
Constant grn:
Link detected.
Constant grn:
Controlled by scan-
ner.
Constant grn:
Online, link establis-
hed.
Flashing grn:
Not congured, or
scanner not active
Flashing grn:
Packet is received or
transmitted.
Flashing grn:
Online, no link esta-
blished.
Transmitter in eld housing PR 5230 4 Device installation
Minebea Intec EN-100