Minebea Intec PR 5230 - Ethernet-IP Interface

1 2 3 4
Flashing 2 Hz grn:
Engineering tool for
identication is acti-
ve.
Flashing 1 Hz red:
Conguration error
Flashing 3 Hz red:
No station name, no
IP address
Flashing 4 Hz red:
Internal error
Legend
--- o
red red
grn green
4.6.9.2 Connection
4.6.10 EtherNet-IP interface
The EtherNet IP interface card has the type designation PR 1721/47.
The eldbus card is equipped with a standard RJ-45 socket  for network connection.
contains a powerful TCP/IP and EtherNet-IP interface connection with transfer rates of 10
or 100 Mbit/s.
The card is inserted into "Slot 2"  (see Chapter 4.6.1).
1. Guide the cable (e.g., patch cable CAT5) into the instrument through the metal sleeve
of the cable gland, strip the insulation, and mount the supplied RJ-45 plug (see
mounting information for connector).
2. Insert the RJ-45 plug into the RJ-45 socket of the eldbus card.
3. Tighten the cable gland of the instrument.
Transmitter in eld housing PR 5230 4 Device installation
Minebea Intec EN-98