Minebea Intec PR 5230 - Fieldbus Parameters

[Printlayout Item 16]
Print layout for line 16
Selection: -none- (no printout; selected if fewer than 6 elements will be printed), Gross
weight, Net weight, Tare weight, Date & Time (printed in format DD.MM.YYYY
HH:MM:SS), Sequence number (counter for individual print orders, max. 6 digits,
#000001 comes after #999999), CR/LF (carriage return and line feed), Device address,
displayed weight, Formfeed
Note:
If [OIML], [NTEP], or [NSC] has been selected, printing is done only if the stability criteria
is fullled.
The weight is shown in "< >".
For [NTEP] or [NSC] the gross weight is indicated with G (otherwise B).
Press to return to the Setup menu.
The following prompt window appears if parameters were changed.
Save the data with [Yes].
Press [No] to exit the menu without changing data.
If a printer has been connected and set up (see Chapter 7.15.1.1), the conguration
printout can be triggered via the and keys (clicked one after the other).
7.15.5 Fieldbus parameters
The eldbus parameters are set under this menu item.
Open the menu via -[Fieldbus parameter].
This menu item can only be selected if a eldbus card is installed.
The protocol displayed automatically depends on of the installed eldbus card:
- [ProBus-DP] for PR 1721/41
- [InterBus-S] for PR 1721/42
- [DeviceNet] for PR 1721/44
- [CC-Link] for PR 1721/45
7 Commissioning Transmitter in eld housing PR 5230
EN-189 Minebea Intec